Note
If the minimum return temperature has been set too low, there is more compres-
sor wear due to the increase in the number of low-pressure shutdowns.
If the minimum return temperature is set too high, the proportion of electrical
heating increases and the degree of efficiency drops. This problem occurs pri-
marily when heating up a cold building.
Access
&
"
Device settings
"
&
"
Programming
"
&
"
Heat pump
"
&
"Min. return temp."
(
1
/
!
)
Standard setting
5 °C
Setting range
1 to 40 °C
Hysteresis T primary/min. T primary in
This setting determines the control range for starting and stopping the heat
pump. The shutdown point of the heat pump is determined by the minimum
brine entry temperature ("
Min. T primary in
").
A
Brine inlet temperature
B
"
Min. T primary in
"
C
"
Hysteresis T brine
"
D
Heat pump ON
E
Heat pump OFF
Access
&
"
Device settings
"
&
"
Programming
"
&
"
Heat pump
"
&
"Hyst. T primary"
or
"Min. T primary in"
(
1
/
!
)
Standard setting
Setting range
"
Hyst. T primary
"
5 K
1 to 20 K
"
Min. T primary in
"
-4 °C
-10 to +20 °C
Minimum return temperature
(cont.)
138
Heat pump control settings
55
92
968
GB
Summary of Contents for VITOCAL 200-G
