Operating instructions
Reduced temperature
Operating instructions
Temperature program, heating circuit
Operating instructions
Remote control
If a remote control is installed, it must be activated for the relevant heating cir-
cuit.
Note
If a remote control is used, the "
Operating mode
" parameter (see following
page) must be set to "
Remote control
". Otherwise the fault indicator will flash
on the remote control.
The remote control must also be programmed for the corresponding heating cir-
cuit. For more information on the use of room temperature sensors and remote
controls, see page 77.
Access
&
"
Device settings
"
&
"
Programming
"
&
"
Heating circuit
"
&
"
Heating circuit 1/2
"
&
"Remote control"
("
YES
"/"
NO
")
Standard setting
NO
Setting range
YES/NO
Operating mode
You can set a fixed operating mode here that will take priority over the operating
mode selected at the operating mode selector.
Standard temperature
154
Heating circuit control settings
55
92
968
GB
Summary of Contents for VITOCAL 200-G
