4.6 Accessories for sound insulation measures
Note
Observe the design information on "sound insulation". See
page 97.
Anti-vibration fittings
Supports
For part no., see pricelist
To avoid the transmission of structure-borne noise during the opera-
tion of the fuel transportation equipment, the braces and the anchors
of the relevant conveyor device are placed on high quality Sylomer
bases (plastic anti-vibration mounts for noise attenuation) or anch-
ored with a Sylomer support and a chipboard plate in the building
structure. The anchor points with heavy load anchors are separated
from the supports with Sylomer washers.
Standard delivery:
■ Sylomer washer
■ Sylomer pad
■ Sylomer base
■ Chipboard plate for the supports of the respective equipment
Available supports for:
■ Discharge screw conveyor
■ Screw conveyor
■ Feed
■ Flexible agitator discharge
■ Horizontal discharge
■ Ash removal
■ Flue gas dust extractor
Note
■ One anti-vibration fitting should be used for each means of fuel
transport, e.g. 1 pce AH + 1 pce anti-vibration fitting AH-AS
■ Installation room characteristics relating to the physical building
structure largely determine the transmission of structure-borne
noise in the building. It is important to note that the specified
measures cannot provide complete noise and vibration isolation.
■ Building related measures (wall openings, fire barriers, floating
screeds, etc.) must be coordinated with structural engineers and
architects and are not included in the standard delivery and there-
fore not within our area of responsibility.
Installation accessories
(cont.)
34
Viesmann
VITOFLEX 300-UF
4
5682428
