14
Change the address code if the wireless
connection between the Vitotrol 100 and
the wireless receiver fails.
1.
Press and hold
B
on the wireless
receiver (see diagram on page 12) for
approx. 10 s until LED
r
flashes.
2. Carry out the following settings on
the Vitotrol 100:
Open the flap of the Vitotrol 100.
3.
Press
twice.
4.
Select
"Settings"
with / .
5.
Confirm with
OK
.
6.
Select
"Service"
with / .
7.
Press
OK
three times to confirm.
8.
Select
"Address code"
with / .
9.
Confirm with
OK
.
After approx. 30 s the display shows
"Transmitting"
.
The transmission takes approx.
30 s.
LED flashes briefly during trans-
mission.
The LED extinguish when the address
code has been recognised. If not, repeat
the process.
Service settings
Changing the address code
5461 060 GB
