19
Setting "Comfort mode" (if available)
Tap the following on-screen buttons:
1. "Heating circuit 1
"
in the header to select the
required heating circuit
2.
The rooms will be heated with the temperature of
the last active time phase for standard room tem-
perature or comfort room temperature.
Ending "Comfort mode"
Again tap on
Or
Automatically, when switching to the next time phase
for standard room temperature or comfort room tem-
perature
Or
Ends automatically after 8 hours
Energy cockpit
In the Energy cockpit, you can check the following
information on the energy status of your micro CHP
system:
■
Power exported to the grid and power drawn
■
Indication of DHW cylinder heating by the gas con-
densing module or fuel cell (energy flow)
■
DHW cylinder temperatures
■
Energy consumption of the heat generator (gas and
electricity consumption)
■
Energy statement of the internal electricity meter
Default display in the energy cockpit
Fig. 6
A
DHW cylinder
B
Gas condensing boiler with flow temperature dis-
play
C
Energy statement checking
D
Fuel cell
Checking the energy status (see page 20)
E
DHW cylinder heating by the gas condensing
boiler or fuel cell enabled (red arrows)
The various components present in the system are
shown as graphics. Some information on the compo-
nents is provided in the default display. To obtain addi-
tional information, tap on the relevant system compo-
nent. See also following chapters.
DHW cylinder
Checking temperatures (see page 20)
Operation
Comfort function
5835784
Summary of Contents for Vitovalor PT2
Page 55: ...55 5835784...
