[
EN ● 7
]
Version: 2g
18.12.2019
To reduce heat loss, usage environment should have reasonable heat protection.
1.
All settings need to be reset after replacing batteries.
2.
Alkaline battery is recommended.
3. Check if set temperature not higher than room temperature first if the heater can not be
turned on by remote.
4.
If users want the week timer and temperature work, make sure the TIMER function has
been switched to ON by long press MODE setting; If users want it not working, switch the
TIMER to OFF.
5. Do not cover or touch the temperature sensor which is at the top of the remote.
6. Do put the remote in a open normal room environment rather not inside a drawer or under
pillow or quilt etc.
7.
Please do change the batteries with new ones once the screen battery symbol gets flas
-
hing, or else it will not be able to control your heaters.
8.
Please do take out the batteries from the remote control if long time no use.
9.
Please pull out the receiver from the socket if long time without using.
10.
Do not destroy the surface of the heater by nail or other edge tool, which may resulting
heating element destruction even electric leakage.
11.
Do not pull the power cord hard.
12.
Do not cover the heater when it is working.
NOTES
9. Long press TIME 3 seconds to set year, month, date and time with UP and DOWN buttons.
10. Press FAV, set temperature will convert to favorite temperature, and it will convert again to week
target temperature at the time when TIMER ON start to work.
11. The symbol “ ” means heating, it only displays when room temperature is 0.5°C (or more)
lower than set temperature.
12. The backlight will be ON when press any button in the state of power-on.
13. The remote control has simple window open monitoring function which means heater will be
turned off/on automatically if room temperature falls down/rises up continuously over 1.5°C within
3 minutes under SMART ON mode.
14. Short press ON/OFF of the receiver to turn on/off the heater directly only if there are no batteries
inside the remote or remote is broken or not within working distance , or else the remote control
will still send on/off commands to the receiver
15. One remote control can be paired to and work with several receivers at same time.
