Installation Guide
Packing list
In addition to this installation sheet, your package should contain:
• 1 x Pendant adaptor
• 4 x M4 self tapping screws
• 4 x O-ring seals
Specifications
• Weight: 8.4oz(240g)
• Mechanical dimensions: 5.5” x 2.75” (140mm x 70mm)
Product specifications subject to change without notice.
Certain product names mentioned herein may be trade names and/or
registered trademarks of other companies.
Please visit our website for more information:
www.deView.com
V531-DC020-200
Ver. 07/2008
A1
A3
A6
A4
A7
A2
A5
A1 :
M4 self tapping screw (1 of 4)
A2 :
Moisture seal O-ring (1 of 4)
A3 :
Base cable entry
A4 :
Enclosure
A5 :
Gasket (supplied attached to pendant mount)
A6 :
Orientation rib (1 of 2)
A7 :
Pendant mount hemisphere
Installing the pendant mount
1 Remove the dome cover and camera assembly (if fitted)
Follow the insturctions provided with the dome enclosure to remove the
cover and the camera assembly.
Note: When using the pendant mount, the large rubber gasket and outer ring
supplied with the dome enclosure (used when surface mounting) are not
required and must be removed.
2 Open the enclosure base holes
C
arefully open the four base
mounting holes (used for securing
the enclosure
A4
to the pendant
mount
A7
) and also the base cable
entry
A3
.
3 Place the pendant mount
hemisphere in position
Screw the pendant mount hemisphere
onto a suitable conduit that has a 3/4” NPT tread. The pendant mount is also
designed to work with compatible wall mounts, which have a 3/4” thread.
For damp location installations:
Use PTFE tape on the screw thread to ensure a tight moisture proof seal.
If the power and video wiring is not already in place through the conduit,
complete that stage now. Ensure that cable entry from conduit is adequately
sealed with a silicone sealant (or similar) to prevent condensation from inside
the conduit running down into the pendant enclosure.
4 Place the enclosure into the pendant mount hemisphere
Note: Ensure that the two locking arms of the enclosure are fully retracted
(please see enclosure installation sheet for details). Also, ensure that the
large rubber gasket (supplied with the enclosure) is removed and that the
gasket
A5
(supplied with the pendant mount) is seated correctly on the inner
rim of the pendant mount hemisphere.
The enclosure will fit to the pendant mount only in one of two orientations
due to the two extra ribs
A6
which must be aligned with the grooves that are
used by the two locking arms.Feed the power and
video wiring through the enclosure base cable entry.
5 Secure the enclosure using the
four self tapping screws
Connect the video and power cables, limit the
incoming cable length in the pendant mount.
Arrange the cable so they lie in the pendant mount.
Use the four supplied M4 self tapping screws
A1
(each with an o-ring
A2
fitted to form a moisture
seal) to secure the enclosure to the pendant
mount hemisphere.
6 Fit the camera assembly and replace the dome cover
Follow the instructions provided with the dome enclosure (and camera) to fit
the camera assembly, connect the wiring, set-up the camera and replace the
dome cover.
VP-PC
Pendant Cap and (BKPCWM) Wall Mount
NOTE:
Ensure that the top
surface of each hole
(where the screw
o-rings will locate)
are clean and free of
debri
s
.
If necessar
y, use a
flat blade to carefully
remove any material
,
without scratching
the top surfac
e
.
O-Ring
video-power
connectors
