Easy Setup
26
ViewCast
Changing the network settings
For most networks, it is not necessary to modify the default settings. However, if you wish to assign
a static IP address to the Network Interface Cards (NICs), you may change the network setting using
the front panel menu.
To change the network settings:
1.
Press the
Menu
button. The system menu appears.
2.
Select the
Setup System
option.
Note: Use the Up and down arrow buttons to select the proper option.
3.
Press
Enter
. The setup menus appear (Figure 14).
Figure 14. Setup menus
4.
Select
Network
.
5.
Press
Enter
. The network interface screen appears (Figure 15).
Figure 15. Interface screen
6.
Select the network interface you wish to modify.
7.
Press
Enter
. The settings screen appears (Figure 16).
Figure 16. Settings screen
8.
Select
Change Settings
.
9.
Press
Enter
. The network settings screen appears (Figure 17).
Figure 17. Network settings screen
Note: Once you modify the setting, the system saves the changes until you modify the
settings again or until you restore the system back to its original factory settings.
10.
Select
DHCP On/Off.
Summary of Contents for Niagara Pro II
