2
1.4. Installing and Removing Table Stands (optional)
To install table stands:
1. Ensure your display is powered off.
2.
Spread a protective sheet on a flat surface.
3. Grab the carrying handles and place the display face-down on the protective sheet.
4. After inserting the stand in the guide block, tighten the screws on both sides of the display.
NOTE:
The longer side of the stand should face the front of the display.
Carrying handle
Guide block
Thumbscrews
Table stand
Longer portions face the front
To remove table stands:
1. Power off the display.
2.
Spread a protective sheet on a flat surface.
3. Grab the carrying handles and place the display face-down on the protective sheet.
4. Remove screws using a screwdriver and place them in a safe place for reuse.
Summary of Contents for CDX5552
Page 62: ...52 ...