ViewSonic EP1031r, User Manual

i

Compliance Information

NOTE:

 This section addresses all connected requirements and statements regarding 

regulations. Confirmed corresponding applications shall refer to nameplate labels 

and relevant markings on unit.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) this device may not cause harmful interference, and (2) 

this device must accept any interference received, including interference that may 

cause undesired operation.

NOTE: 

This equipment has been tested and found to comply with the limits for 

a Class A/Class B digital device, pursuant to Part 15 of the FCC Rules. These 

limits are designed to provide reasonable protection against harmful interference 

when the equipment is operated in a commercial environment. This equipment 

generates, uses, and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful interference to radio 

communications. Operation of this equipment in a residential area is likely to 

cause harmful interference in which case the user will be required to correct the 

interference at his/her own expense.

• 

Reorient or relocate the receiving antenna.

• 

Increase the separation between the equipment and receiver.

• 

Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

• 

Consult the dealer or an experienced radio/TV technician for help.

Warning: 

To comply with the limits for the Class A/Class B digital device, pursuant 

to Part 15 of the FCC Rules, this device must be installed in computer equipment 

certified to comply with the Class A/Class B limits. All cables used to connect the 

computer and peripherals must be shielded and grounded. Operation with non-

certified computers or non-shielded cables may result in interference to radio or 

television reception. Changes and modifications not expressly approved by the 

manufacturer could void the user’s authority to operate this equipment.

RF exposure warning statement

This equipment must be installed and operated in accordance with provided 

instructions and the antenna(s) used for this transmitter must be installed to provide 

a separation distance of at least 20 cm from all persons and must not be co-located 

or operating in conjunction with any other antenna or transmitter. End-users and 

installers must be provide with antenna installation instructions and transmitter 

operating conditions for satisfying RF exposure compliance.