ViewSonic VX2475Smhl-4K VS16024, User Manual

i

Compliance Information

NOTE:

 This section addresses all connected requirements and statements regarding 

regulations. Confirmed corresponding applications shall refer to nameplate labels 

and relevant markings on unit.

FCC Compliance Statement

This device complies with part 15 of FCC Rules. Operation is subject to the following 

two conditions: (1) this device may not cause harmful interference, and (2) this 

device must accept any interference received, including interference that may cause 

undesired operation.

This equipment has been tested and found to comply with the limits for a Class 

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed 

to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses, and can radiate radio frequency 

energy, and if not installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined 

by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

• 

Reorient or relocate the receiving antenna.

• 

Increase the separation between the equipment and receiver.

• 

Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

• 

Consult the dealer or an experienced radio/TV technician for help.

Warning:

 You are cautioned that changes or modifications not expressly approved 

by the party responsible for compliance could void your authority to operate the 

equipment.

Industry Canada Statement

CAN ICES-3 (B)/NMB-3(B)

CE Conformity for European Countries

The device complies with the EMC Directive 2004/108/EC and Low Voltage 

Directive 2006/95/EC.

Following information is only for EU-member states: 

The mark shown to the right is in compliance with the Waste Electrical and 

Electronic Equipment Directive 2012/19/EU (WEEE).The mark indicates 

the requirement NOT to dispose the equipment as unsorted municipal 

waste, but use the return and collection systems according to local law.