INSTALLATION
DIMENSIONS
• This device may not cause harmful interference
• This device must accept any interference received, including interference
that may cause undesired operation.
Specification subject to change without notice.
PRECAUTIONS
REGULATORY NOTICE
Do not use the camera if fumes, smoke or a strange odor is emitted from
the unit, or if it seems to not function correctly. Disconnect the power source
immediately and consult your supplier.
1. Stick the Installation location sticker on the Installation surface, Drill
four holes based on the marks on the sticker. Drive the swell plastic
buttons into the holes.
2. Take out the camera and remove the installation bracket, use screws
with a length of 30mm to fix the installation bracket, as shown in
figure
B
.
3. Connect the multi-connector cable.
4. Rotate and remove the cover, as shown in figure
C
.
5. Aim the four holes of the camera at the screw bolts, Fasten the
screws and fix the camera, as shown in figure
D
.
6. Aim the buckles of the cover at the class gap, push in and rotate the
decoration until it can’t rotate, as shown in figure
E
.
Cover
Attach the bracket
Attach the Camera
Remove the cover
Attach the Cover
Installation Bracket
Always follow the instructions in the installation guide when applying
power. Fire and equipment damage can occur if power is applied
incorrectly. For the correct power supply, refer to the specification sheet.
If installed close to a TV, radio transmitter, magnet, electric motor
transformer or audio speakers the magnetic field generated may interfere
with or distort the image.
Do not install or operate in small, unventilated areas. Heat build up can
significantly reduce the performance and operating life of the product and may
cause a fire.
Whether or not the camera is used outdoors, never point it toward the
sun. Use caution when operating the camera in the vicinity of spot lights or
other bright lights and light reflecting objects.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
To prevent damage, do not drop the camera or subject it to strong shock or
vibration.
Do not use the camera in extreme environments where high temperatures or
high humidity exists. Use the camera under conditions where temperatures are
between 14°F ~ 131°F (-10°C ~ 55°C), and humidity is below 80%.
VZ-FE-1
6MP
IP Fisheye Camera
B
D
C
E
Ø 6.37” / 161.99 mm
2.05” / 52.20 mm
www.avsupply.com | email: sales@avsupply.com | Ph: 858.565.1101
www.avsupply.com
