How to reinstall the top cover
DDR3 SODIMM
mSATA module
module and antenna
2.5-inch SATA SSD
How to install the
How to install the
How to install 3G / 3.5G
How to insert SIM card
How to install the
Step
1
Step
1
Step
2
Step
1
Step
1
Step
1
Step
2
Step
1
Step
2
Step
2
Step
3
Step
2
2
3
5
7
6
4
On the inner side of the top cover, make sure to spread the thermal
Align the notch on the DDR3 memory module with the notch on the
Reinstall the hard drive bay with the 2.5” SATA SSD then connect
Align the notch on the mSATA module with the notch on the mini
Push back firmly the SIM card socket to unlock and open. Pull up
Align the notch on the 3G/3.5G module (EMIO-1541-00A1) with
Gently close the socket by pulling down the SIM socket that
Remove four screws and pull up hard drive bay. Attach the hard
Gently insert the DDR3 memory module into the SODIMM socket
Once the mSATA module has been fully inserted, push down the
Push down the memory module until it snaps into place.
Align the top cover over the mounting holes on the chassis then
paste evenly on the center area of the heat pipe plate. Using a
SODIMM socket.
the SATA data and power cable into the SATA SSD.
PCIe card slot then insert the module at a 30° angle.
the socket and place in the SIM card.
the notch on the mini PCIe card slot then insert the module
at a 30° angle.
contains the SIM card then carefully lock the SIM socket.
drive bay to the 2.5” SATA SSD and secure it with four screws.
at a 30° angle.
module until the screw hole aligns with the standoff hole then
secure it with two screws.
plastic protector, use your finger to spread the paste.
secure the top cover with sixteen mounting screws.
Reminder
Every time the user takes off the top cover, the amount of
thermal grease (between the heat pipe plate and CPU heatsink)
may decrease. Therefore, adding a small amount of thermal
grease is advisable. Use the thermal grease (in tube syringe)
provided in the package.
Note
Ensure the angled of the SIM card is placed in the correct way
before closing the socket.
