AGDS-32 User Manual
Vighnaharta Technologies Pvt. Ltd. Page
11
of
14
How does AGDS-32 work?
After installation as per instructions given in the user guide, the system is ready to use. When the
system is powered on, after initializing the system, it becomes ready to accept input from the
user.
1.
Idle Condition:
Idle condition is nothing but enabling the system for alerting the user against security
breaches / emergencies. While stepping out of the building or premises, user has to power
on the system to activate the security zones.
When user power on the AGDS-32 Panel, then system remains in Ideal condition
In this condition then only GREEN LED (Power On) will be on continuously on front panel
In Ideal condition, the following standby message appears.
2.
Alarm Condition:
Alarm condition is nothing but alerting the user against security breaches / emergencies
when Gas Leak occurs at any Active zones. Once the system is In Alarm condition it puts
the RED LED (Alarm) ON, internal buzzer beeps and the Siren will be on up to its
predefined timeout.
On front panel user can
stop the Siren
by pressing the
Silence
key
to stop Siren.
In Alarm Condition, the following message appears.
The below message shown for zone number 04 is in Alarm Condition:
These two messages will flash alternately on the front panel display of AGDS-32 system
until you reset the alarmed zone from the front panel.
AGDS-32
25/10/2012 12:43
#04 flat name
Z-04 Alarm
System in Alarm
25/10/12 12:54