AGDS-32 User Manual
Vighnaharta Technologies Pvt. Ltd. Page
7
of
14
Power ON the system
To power ON the system, insert the plug of the AGDS-32 Panel into power socket and put it
on.
After GAS detector zones connected to the system, “
AGDS-32”
is a stand by message will
display on first line, and on second line the
date
and
time
appears as shown below.
Then system checks for the system level faults. If any fault exists in the system like Siren
Disconnect then, faults scroll on the display will show Fault indication shown below with
ORANGE LED ON.
View Event Log
The events occurred during the system operations are recorded by the system. The events include
events like Mains Restore, Siren Trouble, and so on. The event appears along with date and time.
System can store 96 events. This menu is available for users. When system is in idle condition,
user can view the event log.
To view event log,
1.
Press
Menu3
key
The following image shows a typical event log in the system.
Use left or right keys to view previous or next events
To delete the event log,
1.
Press
Menu1
key
2.
Press
Menu3
key to select
Config
option
3.
Enter
4 Digit Pin
Note:
In order to delete the event log, user must enter the correct password.
4.
Press
ENTER
key. The LCD appears as shown below.
5.
Press
Menu3
key to select
Del Log
option. The following message appears as below.
10:39:17 25/10
Mains Restore: 00
User Config 2/2
Defaults Del Log
Event Log Erased
Press ESC
Wait For Action
AGDS-32
25/10/2012 03:58
System Fault
No Siren
