TSGR-21 GAS Release Panel User Manual
Vighnaharta Technologies Pvt. Ltd. Page
23
of
43
3. DON’T cause an accidental discharge
Many facilities may have one or more spaces protected by an automatic fire extinguishing system. Unfortunately,
too many system owners have had to deal with an accidental discharge of a system. Facility Managers must take
steps to avoid this at all costs. Without question, the most common reason for a false discharge is human error.
It’s important to put in place and enforce procedures and policies that will minimize the chance for this sort of
error. The single biggest contributor to the prevention of accidental discharges is training the personnel who work
in and around these spaces.
4. DON’T allow unqualified personnel to service your fire system
Facilities Managers must ensure those who are performing these tasks are trained on the equipment they are
servicing. The person working on TSGR-21 unit, must have through knowledge of Fire Sprinkler, Fire Alarm and
Special Hazard Fire Suppression. Facility Managers must not hesitate to ask not only the service provider, but also
the specific technician about their level of experience in the type of work they are performing. The reliability of
your life safety and business continuity depends upon this person.
5. DON’T forget to consider the fire system when your facility changes
One thing is for certain, your building will eventually change and each time it does the Facility Manager must not
forget to evaluate the impact those changes will have on the fire systems protecting the building. Other types of
fire systems and components will no doubt be impacted including Fire Sensors and Panel location.
3.
System Configuration
The gas release panel is completely programmed at site with the help of panel keypad and LCD. It does not
require software skills.
When all zones are in normal state, the screen displays as below. Normal state means no active alarms, troubles
or under configuration / testing mode.
Z1:Nrml Z2:Nrml
24/03/14 10:10
To enter into Programming mode do following steps.
3.1 Programming menu:
The gas release panel TSGR-21 is Programmable for gas release timer, PFC relays, input type etc. When entered
into the menu first shows the screen “SYSTEM MENU”. Use
Right key for next menu. Press Enter key to go
into particular menu.
There are total 6 programming menu options as listed below:
1. System Config
2. Input Config
3. Output Config
4. Event View
