Vigilant
MX1-Au
Operator Manual
Document: LT0439
Page
23 October 2018
Issue 1.73
8-8
From the base display press MENU three times then
MEMORY
F3 to
view the System Memory Status menu.
|
Select memory area to display
status
| DATAFILE
| KEYPAD
| PROGRAM
Fig 8-7 – System Memory Status Menu
Menu options are:
DATAFILE
F2 displays information about the two site-specific
configuration data files. There are two copies of the configuration file;
only one of these will be active at any time.
PROGRAM
F3 displays information about the controller firmware.
KEYPAD
F4 displays information about the LCD/keyboard firmware.
Note the firmware version for each
MX
Loop Card is shown on the
MX
Loop Status screen page 8-5.
Press
DATAFILE
F2 to show the status of the first copy of the site-
specific configuration.
The filename, date and CRCs of the configuration files stored in the
MX1
can be viewed. This will also show which configuration files are active.
Datafile1: Active | ACTIVE
CRC:nnnnnnnn cccc | FILE2
Datafile: SiteConfig | PROGRAM
Written: 22 Aug 2006 09:31:56 | KEYPAD
Even where the datafiles contain the same
programmed information they will show
different CRC values here
Identical programmed configurations will
show identical values here
Fig 8-8 – Site-Specific Data Display – Datafile 1 Active
System Memory Status
Viewing
System
Memory Status
Viewing
Datafile
Status
