- 7 / 20 -
8.
EDID Management
This Matrix has 21 factories defined EDID settings, 2 user-defined EDID modes, and 8 copy
EDID modes. You can select defined EDID mode or copy EDID mode to input port through front
panel buttons, RS-232 control, or Web GUI.
On-panel button operation:
On the initial OLED display screen, press the “MENU” button to
enter the EDID setting interface, press the “UP/DOWN” button to select the required EDID,
and press the “ENTER” button. A prompt “copy to input:” will appear. Then press “the
UP/DOWN” button to
select the input port you need to set and press the “ENTER” button again to confirm this operation
.
RS-232 control operation:
Connect the Matrix to PC with a serial cable, then open a Serial
Command tool on PC to send ASCII command “s EDID in x from z!” to set EDID. For details,
please refer to “EDID Setting” in the ASCII command list of “10. RS-232 Control Command”.
Web GUI Operation:
Please check the EDID management on the “Input page” of “9.
Web GUI User Guide”.
Summary of Contents for VL-MX88-1
Page 1: ...VL MX88 1 8x8 HDMI 2 0 Matrix 18Gbps VER 1 1...
Page 12: ...10 20 Password user admin...
Page 24: ...22 20...