105
3-6.3 Port Group
Filtering
Parameter
Description
The section describes how to you could to set the port group filtering in the mld
snooping function. On the UI, you could add new filtering group and safety policy.
Web Interface
To configure the MLD Snooping Port Group Configuration in the web interface:
1.
Click Configuration, MLD Snooping, then Port Group Filtering Configuration.
2.
Click “Add New Filtering Group”.
3.
Specify the filtering groups with entries per page.
4.
Click “Apply” to save the setting.
5.
If you want to cancel the setting, click the reset button to revert back to
previously saved values.
Figure 3-7.3: The MLD Snooping Port Group Filtering Configuration
Delete:
Check to delete the entry. It will be deleted during the next save.
Port:
The logical port for the settings. You can evoke to enable the port to join
filtering Group
Filtering Groups:
The IP Multicast Group that will be filtered.
Buttons:
Apply –
Click “Apply” to save changes.
Reset-
Click “Reset” to undo any changes made locally and revert back to
previously saved values.
