112
3-7.2 Port Group
Allow
Parameter
Description
The section describes how the user could add the IP Multicast Group, which
allowed to receive the multicast stream. Entries in the MVR port group allow table is
shown on this page. The MVR Port Group Table is sorted first by port, and then by IP
address
Web Interface
To display the MVR Groups Information in the web interface:
1.
Click Configuration, MVR, then Port Groups Allow.
2.
If you want to add the new allowed group, you need to click the “Add New
Allow Group” button.
3.
Evoke the “Port No.”, “Start Address”, and “End Address”.
4.
To click the “Apply” to apply the configuration of MVR port group allow
table.
Figure 3-7.2: The MVR Groups Information
Delete:
Check to delete the entry. It will be deleted during the next apply.
Port:
The logical port for the settings.
Allow Groups:
The IP multicast group that will be allowed.
Adding New Allow Group:
Click “Add New Allow Group” to add a new entry to
the group allow table. Specify the port and allow group of the new entry. Click
"Apply".
Buttons:
Apply –
Click “Apply” to save changes.
Reset-
Click “Reset” to undo any changes made locally and revert back
to previously saved values.
