136
3-9.3 Power Delay
This page allows the user to set the delay time of the provided power after the
device reboot.
Web Interface
To display Power over Ethernet Status in the web interface:
1.
Click Configuration, PoE, and Power delay.
2.
Enable the port to the power device.
3.
Specify the power providing delay time when reboot.
4.
Click “Apply” to apply the change.
Figure 3-9.3: The POE Power Delay
NOTE:
The delay time and actual time might have about 15 sec gap. The 15 sec
gap is for the switch to implement the action of PD detection by PoE, and
configuration loading. At the same time, PD process boot up procedure. So,
different PDs may result in different gaps on delay time.
