MODEL VG6072
9
6. Replace the door (#1) back into place in
the open position. Screw the door
securely to the wall with 1 5/8" screws
(#7).
One installer will need to hold
the door in place while the other
installer screws the hinges to the wall.
Make sure not to rest the bottom door
seal strip on the curb.
C6
1
OPEN
POSITION
4
3
4
1
5. Clean the door glass panel (#1) edges
where the door bottom seal strip (#4) is to
be installed with rubbing alcohol. The door
bottom seal strip (#4) will have to be fit
and cut to the proper size. Verify that the
lip of the seal strip faces toward the inside
of the shower cabin before seal strip
installation. Install the seal strip according
to the diagram.
NOTE: If the seal strips are not flat, use a
hair dryer to apply minimal heat and press
the seal strip back into position.
C5
!
7
2
