FIG.2
A
B
FIG.2A
9
12
THIS EDGE LOOKS
OUTSIDE OF THE SHOWER
THIS EDGE LOOKS
INSIDE OF THE SHOWER
19
6
MODEL VG06011
SLIDE TOP OFF TO
INSTALL 3/4" SCREW
INSTALLATION STEPS
A.
INSTALLING THE BOTTOM RAIL
1.
Remove the aluminum cover from the front piece of the bottom rail by sliding it out.
2.
Remove top of the corner joint. Slide the bottom corner joint (#12) onto the bottom rail (2 pieces)
(#9). [SEE FIG.2]
3.
Align the bottom rail and corner joint to the desired position on the shower base. Make sure the A
and B distances are correct (see page 3 for A and B distances). Prior to drilling, dry fit everything
making sure that everything is straight, level and plum. Pre-drill for sinkers and
tap sinkers. Cut excess sinker off with hacksaw or sharp blade. Dip screws in silicone. [SEE
FIG.2A] Screw corner joints and rails down. Silicone tops of screws.
4.
Seal the bottom rail with clear silicone caulk and center its sides to the base.
5.
Clip the aluminum cover to the front piece of the bottom rail making sure the lower side faces the
inside of the shower. [SEE FIG.3]
6.
Silicone the underneath portion of the corner joint cap and place it on the corner joint. [SEE
FIG.3]
OUTSIDE
INSIDE
ALUMINUM COVER
FIG.3
INSIDE
OUTSIDE
CORNER JOINT CAP
Summary of Contents for VG06011
Page 14: ...MODEL VG06011 14 VG06011 RIGHT DOOR VG06011 LEFT DOOR ...
Page 23: ...7 1 2 Cf FIG 4 3 4 dessus pour la remettre en position ...
Page 31: ...15 ...
Page 48: ...15 MODELO VG06011 ...
