MODEL VG06041
20
FIG. 1
HEX SCREW
ROLLER (3)
ROLLER (3)
SMALL HEX
HOLE
SMALL HEX
HOLE
3/8" VARIANCE
Lowest position
Normal position
Highest position
FIG. 1A
IMPORTANT
NOTE: These adjustments are approximate. You may need to adjust the direction of the small
hex hole to meet your needs.
IMPORTANT
ROLLER ADJUSTMENTS TO ACCOMMODATE OUT OF SQUARE OPENINGS
1.
Loosen the hex screw to allow for movement. Then place the allen key in the small hex hole as
shown and roll it to the right or left to make the adjustment. [See Fig.1]
2.
Fig. 1A displays the 3 different positions.
3.
If your walls are plumb and level, follow the configuration in Fig. 2.
4.
If your wall is off on the top, the rollers should be adjusted as shown in Fig. 3.
5.
If your wall is off on the bottom, the rollers should be adjusted as shown in Fig. 4.
NOTE: There is a 3/8" adjustment in the roller to use in the case that your walls are not plumb
and level. Using an allen key, you will be able to adjust the roller to accommodate for the
variance.
