MODEL VG6072
6
1
1
3
HINGE
OUTLINE
3
1
3
LONGER FLANGE
SHOULD BE ON THE
INSIDE OF THE SHOWER
INSTALLATION STEPS
A1
A. INSTALLING THE SPLIT WALL SIDE SEAL STRIP
1.
Clean all glass panel edges receiving seal
strips with rubbing alcohol. Cut and install
the seal strip (#3) according to the seal strip
diagram, making sure that the longer of the
flanges is on the inside of the shower.
NOTE: If the seal strips are not flat, use a hair
dryer to apply minimal heat and press the seal
strip back into position.
B. HINGE INSTALLATION
1.
Clean the glass surface where the hinges
(#2) are to be installed with rubbing alcohol.
Position hinges on the door glass panel (#1).
Place gaskets on each side of the door glass
panel. Screw the hinges to the door glass
panel with the hex key (supplied).
There is a 1/2" adjustment in the
glass holes where the hinges are
installed. You may need to adjust your
hinges more than once to close your unit
opening properly.
B1
VIEW FROM INSIDE OF THE CABIN
1
!
THIN GASKETS
PLATE
HEX SCREWS
THIN GASKETS
PLATE
HEX SCREWS
