24
3 Design and Function
5.
Press the
|
}
key to confirm the position of
the battery if the surface charge is detected.
Follow the tester ‘s steps to
remove the surface charge
if it happens.
6.
Testing battery.
7.
When test is completed, the display shows the
results as following {Press the
|
}
key to select:
SOH (STATE OF HEALTH) or SOC (STATE OF
CHARGE)}.
GOOD & PASS
XX.XXV XXXXSAE
GOOD & PASS:
The battery is good & capable
of holding a charge.
GOOD & RECHARGE
XX.XXV XXXXSAE
GOOD & RECHARGE:
The battery is good but needs to
be recharged.
RECHARGE & RETEST
XX.XXV XXXXSAE
RECHARGE & RETEST:
Battery is discharged. The bat-
tery condition cannot be deter-
mined until it is fully charged.
Recharge & retest the battery.
BAD & REPLACE
XX.XXV XXXXSAE
BAD & REPLACE:
The battery will not hold a char-
ge. It should be replaced imme-
diately.
BAD CELL & REPLACE
XX.XXV XXXXSAE
BAD CELL & REPLACE:
The battery has at least one
cell short circuit. It should be
replaced immediately.
8.
End of test. Proceed the printout if needed.
TEST IN VEHICLE?
NO
TESTING
Summary of Contents for V3748
Page 34: ......
