18
ViGOR GmbH
•
;
Am Langen Siepen 13-15 • 42857 Remscheid • GERMANY
[
+49 (0) 21 91 / 97 95 •
\
+49 (0) 21 91 / 97 96 00 •
]
info@vigor-equipment.com •
^
vigor-equipment.com
A
1. Affi x 6 Phillips-Recess screws M6 A on
the rear side to secure the support later. Do
not tighten the Phillips-Recess screws M6 A
completely. Tighten until about 3 to 5 screw
threads remain, in order to affi x the support
bracket later.
Can be mounted
to the wall
Safety fi rst
Step 1
2. Place the work bench in the desired
location and attach the support bracket
(
6
,
7
,
8
) as shown in the diagram below.
Attach the support bracket in the correct
position as marked below. The support
brackets are labelled and can therefore
be easily identifi ed.
6
The right support
bracket is suitable for the right side of the
work bench. It is located on the side of the
wall cabinet.
1
.
7
The middle support
bracket is suitable for the middle position of
the work bench.
8
The left support bracket
is suitable for the left side of the work bench.
Please make sure that the VIGOR Storage-
System (VSS) is properly fastened and secured
against falling over. To this end, you have the
option of attaching and securing the VSS to the
wall using the screw holes provided on the rear
side.
Fastening materials are not included in delivery.
Please ensure that the construction of the wall
or mounting base provides for a secure attach-
ment!
Please also ensure that the worktops can
be secured from below through the wall
unit module's provided openings. For this
we recommend standard wood screws
(not included in delivery).
Note
