3
4
3.Description of parts
Positive
slide Holder
Negative
film Holder
4.Loading Slides
Hold up the slide toward the light. Face the
trademark side of the slide away from you.
Look through the slide and it should appear
normally (not a mirror image).
Now turn the slide so the image is upside
down while looking at the same side.
Open the slide holder at the marked spot
on the top.
With the slide holder laid open place the
slide into recessed area in the holder- the
slide should fit perfectly.
Note
: Handle slides with care. Any dust
scratches or fingerprints will show up on
your saved images. If possible use cotton
gloves when handling slides. It is
recommended to use compressed air to
remove any dust on the slides. This is not
included with the film & photo scanner but
can be purchased from an office supply or
electronics retailer.
Close the slide holder and press the
edges so that it locks in place.
Hold it in the position as shown in the
film & photo scanner.
Insert the Slide Holder into the slot on
the right side of the film & photo scanner
as shown.
