5
6
5.Loading Negatives
Hold up the negative toward the light. As you
look through the negative you should be able
to read the small negative numbers normally
(not a mirror image).
Now turn the negative so the image is upside
down while looking at the same side.
Open the negative holder at the marked spot
on the top.
With the negative holder laid open place the
negative into holder so the notches line up with
the notches on the holder.
Note
: Handle negatives with care. Any dust,
scratches or fingerprints will show up on your
saved images. If possible use cotton gloves
when handling negatives. It is recommended
to use compressed air to remove any dust on
the negatives. This is not included with the film
& photo scanner but can be purchased from an
office supply or electronics retailer.
Close the negative holder and press the edges
so that it locks in place
Hold it in the position as shown in the film &
photo scanner.
Insert the negative holder into the slot on the
right side of the film & photo scanner as shown.
Film Holder:
The design of film holder is follow
ISO standard. In some cases the holes on the
film will not match exactly to alignment of the
holder. This is caused by a non-standard camera.
In this case there will be a small black line on
the edge of the frame that can easily be cropped
out using the BlazePhoto software.
ISO--
International Organization for Standardization
6: Loading photo
First insert the photo into appropriately sized photo tray (5
x7
, 4
x6
,
3
x5
)
Note
: Handle photo with care. Any dust scratches or fingerprints will show
up on your saved images.
Insert the photo tray into the photo tray slot from the top of the film & photo
scanner as shown.
