9
Installation
1
2
1
2
Pull out warming drawer
pan until fully extended.
Slide finger along right and left side
until you reach the black hand latches (located at
the front of the rails). Pull up on both the right
and left latches and pull out drawer pan support.
2”
(5.1 cm)
2”
(5.1 cm)
Electrical opening
(from rear)
3
2
1
1
4
Feed supply cord up through
hole in rear of warming drawer.
1
2
5
Remove strain relief bracket and mounting
screws on the terminals.
Attach the white (neutral) and black (line) lead
terminals. Attach ground wire to the
center terminal.
1
2
6
Push supply cord toward terminal
block to relieve strain, reattach supply cord strain
relief bracket over supply cord.
