22
Programming Features Index
DESCRIPTION
Section
Page
Connect/Disconnect
A
19
VLAN Settings
D
21
Unit Name
1
23
SIP Server
2
23
Peer to Peer Settings
3
23
Outbound Proxy
4
23
Authentication ID
5
23
Register Fails
6
23
Speed Dial Numbers
7
24
Security code (factory set to 845464)
8
24
ID Number
9
24
Access Code (1 - 6 digits, blank = disabled, factory set to 123456)
10
24
Audio File
11
24
Recording Emergency Announcement from a phone
12
24
Internal / External Relay (factory set to Internal)
13
25
Relay Mode (Door Strike, Outbound Call, In / Outbound Call, Doorbell, LV-1K Control, Ring, Ring Flash, factory set to Door Strike)
14
25
Relay Activation Command (1 or 2 digits, factory set to
)
NOTE:
Relay Mode must be set to Door Strike
15
26
Relay Activation Time (0.5 - 99 sec, factory set to 5 sec)
16
26
Relay Buzz Volume (1 - 3 or Disabled, factory set to 3)
17
26
Relay Latch Commands (Enabled or Disabled, factory set to Enabled)
NOTE:
Relay Mode must be set to Door Strike
18
26
Alternating Switch Action (factory set to Enabled)
19
26
Speaker Mode (ON, OFF / Silent Monitor or OFF until Answered, factory set to ON)
20
26
Speaker Volume (0 - 9, factory set to 3)
21
26
Ring Volume (0 - 9, factory set to 5)
22
26
Microphone Volume (0 - 9, 0 = Auto, factory set to 5)
23
27
Talk/Listen Delay (VOX) (0.1 - 0.9 seconds, factory set to 0.5 seconds)
24
27
In-Band Audio Call Progress (Enabled, Disabled, factory set to Enabled)
25
27
In-Band Audio Detect Sensitivity (1 - 9, 1 = minimum, 9 = maximum, factory set to 5, power cycle unit after setting)
26
27
Repeat Announcement Option (factory set to 1)
27
27
Lap Counter ( 1 - 9 or Disabled, factory set to Disabled)
28
27
Call Length Time Out (disabled or 1 - 9 minutes, factory set to 3 minutes)
29
27
Inbound Call Mode (Disabled, Auto Answer, Auto Answer-Secure, Ring, Ring with AGC, Factory set to Auto Answer)
30
28
Ring Cadence (factorty set to Normal Ring, 2 seconds on 4 seconds off)
31
28
Dial Next Number on RNA (Ring No Answer) (disabled, 1 - 9 = number of rings, factory set to 7)
32
28
Dial Next Number on Busy (disabled or enabled, factory set to enabled)
33
28
Send ID Numbers as (RFC 2833 or In Band DTMF, factory set to RFC 2833)
34
28
Call LED Mode (OFF, Entry Phone, Emergency Phone or Emergency Outbound only, factory set to Entry Phone)
35
29
Call LED Control (Automatic or enter
to light, factory set to Automatic)
36
29
Mute Current / Next Alarm
37
29
Permanent Alarm Mute (factory set to Alarm Tones Enabled)
38
30
IP Firmware
39
30
Unit Firmware
40
30
Import/Export
41
30
Clear Phone Settings
42
30
Clear IP Settings
43
30
Diagnostics (used to check mic, speaker and relay operations)
44
30
