23
3. Peer to Peer Settings
When set to Peer to Peer mode, a SIP server is not used. The unit should be programmed with a Static IP Address and
Username, a password is not used. Caller ID can be programmed if needed. Simply call the unit by entering the pro-
grammed “username@192.168...(Static IP address for the unit)”. The static IP address is normally programmed into a
page button on the VoIP telephones.
6. Register Fails (Re-Resolve or Alternate Server)
4. Outbound Proxy
If your SIP provider requires an outbound proxy IP address enter it in the Outbnd Proxy field. If outbound proxy is not
required enter the SIP sever IP address into the Outbnd Proxy field.
NOTE:
If not required, this field must match your
SIP server IP address.
5. Authentication ID
If your SIP provider requires Authentication ID, enter it in the Authentic. ID field. If Authentication ID is not required,
leave this field blank.
2. SIP Server
1. Unit Name
Up to a 31 character unit name can be assigned to the
1600-IP Series
Phone being programmed.
Programming Features
When registered to a SIP server in the event that registration is lost you can program the unit to re-resolve using the
current SIP server IP address or route pages through an alternate SIP server. With Alternate Server selected enter the
IP address of the alternate SIP server in the field next to the Register Fails drop down box.
Note:
With an alternate
SIP server IP address programmed, the IP address for the SIP server and alternate SIP server will be limited to 31
characters.
Enter the IP address or URL of your SIP server or service provider in this field. The SIP server IP address is limited to
74 characters.
Note:
If an alternate SIP server IP address is programmed, the IP address for the SIP server and
alternate SIP server will be limited to 31 characters.
Note:
If outbound proxy is not required, enter the SIP server IP
address into the Outbnd Proxy field.
