DFUD042 / DFUD142
CHANGING A PROGRAM AFTER THE UNIT HAS STARTED
The dishwasher is programmed to stop operating if the door is opened during a cycle. If
you want to change a program or option after starting the machine, open the door slightly
to let the spray arms stop rotating and avoid getting sprayed with water. Press and hold
START for three (3) seconds to cancel the current selection then press the touch pad(s)
for your desired selection. Press Start again and close the door. The drain pump will run
to remove any dirty water from the dishwasher before starting the newly selected cycle.
Check to make sure there is still detergent in the detergent dispenser.
WHEN THE WASH IS FINISHED:
The indicator lights will come on for the last wash program and options that you used.
(NOTE: The unit will not retain the Rinse/Hold or Quick program.)
7
Summary of Contents for Custom Front DFUD042
