© 2010 Viking Preferred Service
33
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Service Diagnostics and Procedures–Disassembly
Upper Refrigerator Light Assembly
To access the upper light assembly:
1.
Remove upper refrigerator light bulbs
(see
upper refrigerator light bulb section, page 32).
2. Remove screws securing upper light assembly.
3. Lower light assembly and disconnect wiring.
4. Replace or repair as necessary.
5. Reverse procedure to reinstall.
Lower Refrigerator Light Bulbs
The unit uses standard 40W, 120VAC light bulbs to
illuminate the refrigerator compartment.
To access the lower light bulbs:
1.
Open refrigerator door and remove shelves
as necessary.
2.
Remove lower light bulb cover by pressing
in tabs.
4. Remove/replace light bulb.
5. Reverse procedure to reinstall.
Screw
Tabs
