© 2010 Viking Preferred Service
51
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.
Service Diagnostics and Procedures–Disassembly
Dispenser LED Board
1.
Remove dispenser bezel
(see dispenser bezel
section steps 1-3, page 50).
2.
Disengage tabs to remove LED board from
control bracket.
3. Repair or replace user LED board.
4. Reverse procedure to reinstall.
Water Fitting, Ice Guide,
Ice and Water Paddle Assemblies
1.
Remove dispenser bezel
(see dispenser bezel
section steps 1-3, page 50).
2. Remove grounding screw.
3.
Disconnect wiring connector and wiring to
switches. Remove securing screws to remove
control bracket.
LED Board
Grounding Screw
Connector
Wiring
Screw
Control Bracket
Tabs