Grasping the bezel on both sides, pull away from
the door cavity.
Note:
Bezel needs to be pulled from the bottom
first and then pull slightly downward to clear
the water dispensing tube.
Store bezel and spill tray in safe and secure place until
installation.
7
3
8
For re-installation steps, see pages 50-51.
Remove two additional screws under top
section of bezel.
Remove mounting support.
5
6
47
48
Remove handle side cabinet screws and trim
with a phillips screwdriver.
Remove handle side door trim screws and panel
with a phillips screwdriver.
Install “Z” brackets onto back side of custom panels.
Note:
If 1/4” back panel is used, the brackets will be
flush to the edge (back panel is 1/4” smaller than
3/4” panel dimension).
Proper “Z “brackets engagement.
Note:
A 1/4” back panel needs to be used to ensure proper
insulation. If back panel is not used, the potential for
condensation is present.
For the last 3” of installation, push evenly on the custom wood panel
near the side door trim in addition to pushing from the handle side.
This ensures side “Z” bracket engagement with hinge side door trim.
1
2
3
1/4”
off edges of
3/4 “ panel
1/4” (0.5 cm) back panel
Door
Door trim
“Z” bracket
3/4 “ (1.9 cm) custom panel
TOP VIEW
3”
4
5
Custom Door Panel Installation (Refrigerator or Freezer)
Align upper and lower “Z “brackets in door trim and
push custom wood panel evenly toward the hinge until
approximately 3” from the hinge side door trim.