ICE and WATER DISPENSER
Water Dispenser Operation:
it takes
approximately 1 minute after initially
connecting refrigerator to household
water supply before water dispenses.
Discard first 10 to 14 containers of water
after initially connecting refrigerator to
household water supply and after
xtended periods of non-use.
•
tainer against
•
tainer against ice
ispenser pad.
•
e ice will continue to fall.
Do not remove container until last of
d
ontainer directly under ice chute and
as high as possible in dispenser area.
after 3 to 5
inutes. Motor resets after 3 minutes
n repeatedly
ispensing crushed ice. Allow “snow”
perates only with cubes of
roper size and crescent shaped cubes to
e bucket.
e
Dispense water by pressing sturdy
wide mouthed con
water dispenser pad.
Stop water dispensing by releasing
pressure on pad. A small amount of
water may continue to fall. Spill
shelf is not self-draining.
•
Large
spills should be wiped dry.
Ice Dispenser Operation:
Select cubed or crushed mode by
sliding lever on dispenser panel.
Dispense ice by pressing wide
mouthed con
d
Stop ice dispensing by releasing
pressure on pad before container is
full. Som
ice falls.
IMPORTANT: Reduce spraying of
crushed ice by holding wide mouthe
c
If dispensing ice continuously, dispenser
motor is designed to shut off
m
and dispensing can continue.
A slight delay occurs when switching
between cubed and crushed modes.
Pieces of crushed ice will vary in size
and shape. “Snow” may form on door
and ice chute whe
d
to evaporate or wipe dry.
Dispenser o
p
ic
41
Summary of Contents for DFSB483D
