121
DE
FR
NL
IT
EN
0478 131 9923 B - EN
In linking sections, the perimeter wire (1)
must be routed parallel, the wires must not
cross and must be close to one another.
Attach the linking section to the ground
with a sufficient number of fixing pins (2).
11.8 No-go areas
No-go areas have to be installed
– around obstacles that the robotic
mower must not touch
– around obstacles that are not
sufficiently sturdy
– around obstacles that are too low.
Minimum height: 8 cm
VIKING recommends
●
blocking off obstacles by means of no-
go areas or removing them,
●
checking no-go areas after initial
installation or after changes to the wire
installation using the "Test edge"
command. (
No-go areas must have a
minimum
diameter
of 48 cm.
The
clearance between the edge
loop
A
must be greater than 44 cm.
In order for docking to take place
smoothly, no no-go area must be installed
within a radius of at least
2 m
around the
docking station (1).
Route the perimeter wire (1) from the edge
to the obstacle with the correct clearance
(use iRuler) around the obstacle (2) and
attach it to the ground with a sufficient
number of fixing pins (3). Then route the
perimeter wire back to the edge again.
The perimeter wire must be routed
parallel
and
without crossover
in the
VIKING recommends laying linking
sections together with the relevant
no-go areas or secondary areas
during wire routing.
In the case of retrospective
installation, the wire loop must be
cut and linking sections must then
be integrated using the wire
connectors supplied. (
Summary of Contents for MI 422
