EN - 26
Regular Maintenance
HYDRO TRANSMISSION SERVICE
Transmission Service Information
Service Interval:
Check Oil Level Every 250 Hrs
Transmission Oil Capacity:
Approx. 2-1/2 Quarts
Transmission Oil Type:
SAE 10W-30 with a minimum
API rating of SG/CD.
The Tuff Torq K-56 hydrostatic drive transmission does
not require regular maintenance other than checking the
oil level every 250 hours. See your Authorized Dealer for
transmission service.
Attention:
It is critical that dirt and water be kept out of
the transmission. Thoroughly clean and dry all the sur-
rounding surfaces before opening the transmission.
1. Tilt the seat forward to access the battery compart-
ment (Figure 14)
2. Remove the battery and clean the battery compart-
ment. (See Battery Maintenance).
3. Clean off the fill plug (see Figure 15) and surrounding
area.
4. Using a screwdriver, pry the fill plug out of the trans-
mission and remove the spring.
5. Check the oil level. The transmission should be filled
with oil up to the top notch (see Figure 15 inset).
If not, add oil.
6. Replace the fill plug. Reinstall the battery.
(See Battery Maintenance).
7. Perform the transmission purging procedure found in
the Service section.
Do not allow dirt, water, or other debris to
enter the expansion chamber or
transmission. Even a small amount of dirt can
damage the transmission
Figure 14. Seat Adjustment
A. Seat
B. Battery Compartment
Figure 15. Hydro Transmission Fill Plug Location
Fill To
Bottom of
Top Notch
Fill Plug
A
B
Summary of Contents for MT 830
