EN - 27
Engl
ish
Deutsch
F
rançais
Regular Maintenance
EXHAUST SCREEN SERVICE
Service Interval: Every 50 Hours
Inspect, clean or replace the exhaust screen after
every 50 hours of operation.
1. Park the tractor on a level surface. Disengage the
PTO, turn off the engine and set the parking brake.
Remove the key.
Allow the engine and muffler to cool.
2. Remove the screw (B, Figure 16). Using a pair of pli-
ers, remove the exhaust screen (A).
3. Inspect the screen. Shake any particles from the
screen. If necessary, clean the screen with a wire
brush and safety solvent. Reinstall the screen or if it
is excessively dirty or damaged, replace it.
The Battery is free of Maintenance
Connecting the Battery
See Figure 17. Connect the battery cables (positv cable first,
B, Figure 17). Position the positive battery cable over seat
switch harness to prevent harness from becoming pinched in
seat pivot. Make sure that protective terminal cover (G) is in
place over positive battery post as shown in Figure 17.
Recharging the Battery
Charge the battery for 1 hour at 6-10 amps.
Cleaning the Battery and Cables
Service Interval: Every 100 Hours
1.
First, disconnect the negative battery cable (A)
from the battery terminal (E). Second, disconnect the
positive battery cable (B) from the battery terminal (F)
.
2. Remove the battery from the battery compartment.
3. Clean the battery compartment with a solution of bak-
ing soda and water.
4. Clean the battery terminals (E and F) and cable ends
with a wire brush until shiny.
5. Reinstall the battery in the battery compartment.
6. First, reconnect the positive battery cable (B)
to the positive battery terminal (F). Slide the terminal
cover (G) into place. Second, reconnect the negative
battery cable (A) to the negative battery terminal (E).
7. Coat the cable ends and battery terminals with petro-
leum jelly or non-conducting grease.
Figure 16. Clean / Replace Exhaust Screen
A. Exhaust Screen
B. Screw
Always allow the engine to cool before beginning any
service work were the muffler or exhaust components
must be handled.
Wear gloves when handling exhaust components.
WARNING
BATTERY INSTALLATION
Be careful when handling the battery. Keep flames and
sparks away from the battery.
When removing or installing battery cables, disconnect
the negative cable FIRST and reconnect it LAST. If not
done in this order, the positive terminal can be shorted
to the frame by a tool.
WARNING
A
B
Hood Not Shown
for Clarity
Figure 17. Battery Cables & Fill
A. Negative Cable
C. Nut, Lockwasher, & Washer
B. Positive Cable & Cover
D. Capscrew
C
B
E
A
D
C
F
G
FRONT
Summary of Contents for MT 830
