EN - 37
Engl
ish
Deutsch
F
rançais
Troubleshooting, Adjustment, & Service
FRONT-TO-BACK ADJUSTMENT
1. Arrange the blades so they face front-to-back
(Figure 33).
2. See Figure 32. Measure the distance from the ground
to the front and rear tips of the blades as shown.
Front tips should be equal to rear tips or within 3 mm
higher. If not, proceed to step 3.
3. See Figure 34. Loosen the outside nut (A) and turn
the eccentric nut (B) to raise or lower the rear of the
deck. When the mower deck is level, hold the eccen-
tric (B) while tightening the outside nut (A).
Note:
If mower handle drops out of cutting height quad-
rant, turn adjustment nut (A, Figure 35) clockwise to
increase spring tension. DO NOT tighten nut all the way
so that the spring is solid.
Figure 33. Orient Blades Front-to-Back
Figure 34. Front-to-Back Adjustment Nut
A. Nut
B. Eccentric
Figure 35. Handle Tension Adjustment
A. Adjustment Nut
A
A
B
Blade Brake Check
Mower blades and mower drive belt should come to a
complete stop within five seconds after the PTO lever is
disengaged.
1. With tractor in neutral, PTO disengaged and operator
in seat, start the engine.
2. Engage the PTO and wait several seconds.
Disengage the PTO and check the amount of time it
takes for the mower drive belt to stop.
3. If mower drive belt does not stop within five seconds,
see your dealer.
Summary of Contents for MT 830
