IMPORTANT–
Please Read and Follow!
2
3
•
Before beginning, please read these instructions completely and carefully.
•
Use caution during assembly to minimize scratches.
•
The installer should leave instructions with the customer who should retain for future
reference.
Parts Included
Part
Quantity
(1)
(1)
(1)
(1)
Professional Series Handle
Top End Cap
Bottom End Cap
Viking Self-Adhesive Logo
Installation Instructions
Required Tools
3/32 Allen Wrench
2” Plastic Putty Knife
To install brass handle assembly:
1. Assemble the handle and end caps as shown. The handle will fit tightly, but is not
intended to form permanent bond.
2. Position the handle assembly over the mounting studs.
3. Secure the bottom end cap to the bottom mounting stud by turning the set screw; do
not tighten.
4. Secure the top end cap to the top mounting stud in similar fashion.
5. Ensure that the door, end caps and handle are properly aligned.
6. Tighten top and bottom set screws.
To apply the brass logo:
1. Mark the location of the new logo as shown.
2. Wipe the surface with alcohol and allow to dry.
3. Remove protective backing and apply the logo.
Handle & Logo Installation
To remove factory-installed handle:
1. Locate and loosen set screw on the bottom
end cap. Set screw is located on the
underside of the end cap. Set screws need
only be loosened and do not have to be
removed completely.
2. Repeat for the top end cap.
3. Carefully remove the handle assembly to
expose mounting studs.
To remove factory-installed logo:
1. Apply acetone cleaner around the perimeter
of the logo. Wait 1 to 3 minutes to allow
the cleaner to penetrate the adhesive.
2. Slowly pry the logo away from the door with
the plastic putty knife. Do not use metal
objects or excessive force as this could
damage the surface of the door.
3. Once the logo and adhesive are removed,
clean the surface with mild soap and water
and dry thoroughly.
Handle & Logo Removal
3-5/8”
(9.2 cm)
3-1/2”
(8.9 cm)
2
24”
3-5/8”
(9.2 cm)
3”
(7.6 cm)
15”
