USER'S MANUAL
Operating instructions
ROTOGRAPH-D (120V)
(Rev. 1)
20
6.2
6.2
6.2
6.2
Panoramic X
Panoramic X
Panoramic X
Panoramic X----ray examination
ray examination
ray examination
ray examination
6.2.1
6.2.1
6.2.1
6.2.1
Preparing the equipment (refer to
Preparing the equipment (refer to
Preparing the equipment (refer to
Preparing the equipment (refer to Figure 7 and
and
and
and Figure 8))))
If pressing the button "27" the message "
Equipment not set
" is
displayed and the relevant function LED blinks, push the button a
second time in order to display the message concerning the interlock to
be enabled on the sensor.
The messages that can be read during the Panoramic function setting
and the relevant actions to perform are the following:
1. Digital Sensor not Ready:
activate the QuickVision program and
wait for the completion of the initial check.
2. Select PAN/TMJ1:
it is necessary to select
PAN
with the dedicated
button (13) positioned near the sensor
NOTE:
THE SELECTION DONE ON THE HAND CONTROL MUST BE
CONSISTENT WITH THE SELECTION DONE WITH THE BUTTONS
POSITIONED IN THE AREA OF THE DIGITAL SENSOR
.
After completing the system SET UP, adjust the chin support as follows:
Chin support
PANORAMIC (1)
Chin support
SINUS (21)
ADULT
YES
NO
PANORAMIC
CHILD
YES
YES
