NT00000534-KSCR-ECOWATT-08-18-28-38-52-AN-200625
11/76
ENGLISH
3 . 3 Ha n d l i n g
The units are delivered screwed to pallets made to fit the size of the casing.
KSDR ECOWATT
®
air handling units can be handled by pallet truck, forklift truck, or crane. Handling ma
-
chines will be adapted to the load and lifting conditions.
In all cases, the lift will be made at the base of the device mounted on a pallet. The centre of gravity is
located at the centre of the unit.
The device must be handled with care and only in a horizontal position.
I mini
I
Lifting with a forklift truck
P a l l e t D i m e n s i o n s
Si z e
W i d t h l
( m m )
Le n g t h
( m m )
K SC R 0 8
840
1130
K SC R 1 8 - 2 8 - 3 8
950
1380
K SC R 5 2
1145
1400
3 . 4 Lo c a t i o n a n d a t t a c h m e n t
The KSCR ECOWATT
®
must be placed on a horizontal and smooth surface that is able to support the load.
The EXD and EXG models are intended for installation inside or outside of the buildings.
In all cases, provide any ducts, connection accessories, anti-vibration and anti-freezing protection equip
-
ment needed for the water coil. In areas with a high snowfall, additional protection should be considered. It
is important to provide enough space so the panels can be opened, commissioned, and maintained (filter,
fan, coils). Do not place the unit against a wall to avoid the transmission of solid-state noise.
The casing must be attached to a completely flat support by the side holes provided for this purpose. Mount
-
ing should be made on anti-vibration pads or plates and the connection with flexible sleeves is recommended.
Provide the following necessary clearances for maintenance operations:
Different mountings
A
B
C
D
Warning:
•
For electrical heater versions, only positions
A, B and C are possible.
•
With cooling and reversible coil versions, only
positions A and C are possible.
•
With the cooling and reversible coil versions
in position A, reverse the drain tray (see be
-
low)
•
Use anti-vibration compression mounts for
position C.
•
Use anti-vibration suspension mounts for po
-
sition A.
