62
3.3.1 CONFIGURATION RESET.
This procedure is recommended if you want to modify the ID of a video door entry unit previously programmed
and without keeping the programming for operation of the device.
• In the main window touch the
icon and subsequently the
icon.
• Finally touch the
icon to reset the video door entry unit.
Programming the Two Wire.
WARNING! The following operations must be carried out after powering up the system and before pro-
gramming the audio door entry units and video door entry units.
In the same system there must be only one MASTER panel (identification code 1) while any secondary
panels must be set as SLAVES (see the technical documentation related to the particular panel used).
Do the programming of the panels powering only one panel at a time; the master panel must always be
programmed last.
The configuration of the panel parameters can be done in three different ways:
• Directly from the panel itself using the alphanumeric keyboard or with single buttons.
• With PC and USB 02024 interface and “SaveProg” software.
This section will illustrate solely the method of programming with the alphanumerical keypad on the front of the
Two Wire panel; for configuration with the PC see the related technical documentation.
To access the panel configuration menu carry out the following operations:
• Press buttons
and
at the same time.
• Enter the password to access programming; key in “654321” for the first configuration (default password set by
the factory that must then be modified by the installer).
• Press the button
to confirm.
Once in programming mode, use the and push-buttons
,
and
to select the parameters, the push-
button
to confirm changes, and the push-button
to confirm changes.
At this stage it is possible to scroll through the list of all the panel parameters and the related set values; for each
of these it is possible to enter a value that identifies the parameter and the related configuration.
The set values must be within a certain range (maximum value - minimum value) according to the parameters table
attached to the technical documentation of the panel (see, for instance, the table of “TECHNICAL PARAMETERS
OF THE PANEL” illustrated on the following pages).
For the configuration of the Two Wire panels without the alphanumerical keypad, see the related technical docu-
mentation.
Video door entry system
Summary of Contents for 21553.2
