Vimar ELVOX 40636, Instruction Sheet

o  2 A cosf 0.6 - Motor

The 2 relay outputs are separated from each other by main 

insulation at 250 V~ and not by double insulation; because of 

this, for example, do not connect a SELV circuit to an output 

that is adjacent to another one that is connected to the 230 

V~ power supply.

The instruction manual is downloadable from the site 

www.

vimar.com

Installation rules

Installation should be carried out observing current installa-

tion regulations for electrical systems in the Country where 

the products are installed.

Ensure clearance around the appliance so there is sufficient 

ventilation.
There must be no dripping or splashes of water on the ap-

pliance.

WARNING: To prevent injury, the appliance must be secured 

to the wall as described in the installation instructions.
Above the power supply there must be a bipolar circuit break-

er that is easily accessible with a contact gap of at least 3 

mm.

Conformity

LV directive
EMC directive
Standards EN 60065, EN 61000-6-1, EN 61000-6-3.

WEEE - Information for users

If the crossed-out bin symbol appears on the equip-

ment or packaging, this means the product must not 

be included with other general waste at the end of 

its working life. The user must take the worn product to a 

sorted waste center, or return it to the retailer when purchas-

ing a new one. Products for disposal can be consigned free 

of charge (without any new purchase obligation) to retailers 

with a sales area of at least 400m

2

, if they measure less than 

25cm. An  efficient  sorted  waste  collection  for  the  environ

-

mentally friendly disposal of the used device, or its subse-

quent recycling, helps avoid the potential negative effects on 

the environment and people’s health, and encourages the re-

use and/or recycling of the construction materials.

This product was developed using FreeRTOS

TM

 software - 

http://www.freertos.org/

EN

   4

40636