ENGLISH - 13
6.3 Associating a secondary thermostat with a relay
radio actuator (step 3).
This procedure assigns a relay actuator channel to a thermostat
that has been previously autolearned by the system (see para-
graph 6.1).
1. Place the thermostat near the radio relay actuator that is being
associated.
2. Select the channel to associate with the actuator using the
command in the "installation menu" of the thermostat
(see paragraph 4.2).
3. Confirm. The display signals waiting with a rotation of the
symbol cursors.
4. Press the programming button on the relay actuator.
5. If the actuator has been successfully configured, the
mes-
sage appears for a few seconds, alongside the network address
of the programmed device.
WARNING!
In order to ensure correct operation of the system, do not asso-
ciate more than one thermostat with the same relay channel.
6.4 Disassociating a secondary thermostat from a
radio relay actuator.
This procedure removes the association between a relay actuator
and a previously associated thermostat (see paragraph 6.3).
1. Place the thermostat near the relay radio actuator that is to be
disassociated.
2. Disassociate the device using the
command in the
"installation menu" of the thermostat (see paragraph 4.2).
3. Confirm. The display signals waiting with a rotation of the
symbol cursors.
4. Press the programming button on the actuator.
5. If the actuator has been successfully disassociated, the
message appears for a few seconds, alongside the network
address of the programmed device.
Note.
After the disassociation operation, the relay actuator channel will
revert to the inactive state.
