Page 13
shading solutions by
VIMCO
TM
MDU WITH SV-IR INFRARED RECEIVER MODULE
Sivoia
®
system covered by
decorative valence
The SV-IR allows the MDU to be controlled directly with a
Sivoia
®
Infrared Handheld Transmitter (SV-OCIT, SV-3PIT, or
SV-4GD-OCIT). The SV-IR receiver connects to the MDU via a 20 in. (51 cm) cable. This provides the SV-IR receiver
ample mounting range to offset any infrared signal restriction caused by a protective/decorative covering for the shade
system. To extend the IR receiver mounting range, add up to five (5) SV-IR-EXT-10 extension cables (10 ft. [3 m] each).
Note:
To control an individual shade with an IR transmitter, the SV-IR
must
be connected to that MDU. If there is a
Group/Subgroup of MDU’s with the same Room/IR Address (see page 11),the SV-IR need only be connected to
one of those MDU’s to control the entire Group/Subgroup.
- The SV-IR receiver must be located to allow line-of-sight reception of infrared signals.
- The SV-IR has a range of 30 ft. when receiving infrared signals.
- The SV-IR must
NOT
be located near lighting fixtures or in direct sunlight.
- The SV-IR must be located within 50 ft. (15 m) of the MDU it is connected to. Add up to five (5) SV-IR-EXT-10
extension cables (10 ft. [3 m] each).
MDU
SV-IR Infrared Receiver Module
8
