21
7602050
FIG.12
FIG.14
FIG.13
2.6-
Slide the three mounting feet on to the track as
shown in (Fig. 13).
2.7-
Position the feet in the following way (Fig. 14):
a-
The top foot should be positioned on the last tread.
b-
The middle foot should be positioned immediately
next to the spliced joint. If the top section is longer than
the bottom then the foot should be ABOVE the
spliced joint, if not, then the foot should be BELOW
the spliced joint.
c.
The bottom foot should be positioned on the first
tread.
2.8-
Loosely tighten the feet to stop them from moving.
The feet will help to stop the track from moving on the
stairs while the next steps are performed.
2.9-
Location of the power supply:
a-
At the top of the track:
- Feed the long power cable with the ring terminals
from the power supply through the large cavity in the
assembled track.
b-
At the bottom of the track:
- Bring the long power cable with the ring
terminals from the power supply to the
bottom of the track.
2.10-
Slide the track up the stairs and position it centrally
to give you sufficient room to work comfortably at the
bottom of the stairs.
2.11-
Connect the positive ring terminal (WHITE cable)
to the brass connection attached to the busbar as
shown in (Fig. 15/16).
2.12
- Connect the negative ring terminal (BLACK cable)
to the track as shown in (Fig. 15/16).
FIG.11
