33
12. DIGITAL IN: Optical/Coaxial
Connections for audio signals of source devices with
digital sound such as, for example, DVD players.
“Optical” for optical fibre connection and “Coaxial”
for connection via coaxial cable.
13. BT ANT
Connection for the BT Antenna
14. PRE OUT: Preamplifier output
With these two pairs of connectors you can con-
nect the preamplified stereo audio signal of the
currently selected source to additional power
amplifier channels or an active subwoofer. The
signal of this output is independent of the “SPEA-
KER A/B” setting (4) and the plugging-in of a head-
phone (10).
15. REC OUT: Recording output
If desired, you can connect a recording device like
a CD recorder or a tape recorder to this output. The
stereo signal of this output is identical to the output
signal of the selected audio source at one of the
inputs. It is independent of the volume setting (3)
(27), the Tone control (5)(6)(8), the Loudness set-
ting (9), the setting of the Speaker switch (4) and
the plugging-in of a headphone (10).
16. INPUT: S3 - S4
Here you can connect up to two source devices
with stereo audio line level output.
17. MAIN IN (S6)
Power Amplifier Input:
This input is for connec-
tion of a stereo preamplifier or a source equipment
with a pre output. Note that
no
high level output
should be connected from a stereo source to S6. It
is also
not
allowed to connect this to the „Pre-Out“
(14) of the unit.
18. Colour VU-Meter
Use this switch to change the colour of the VU-Me-
ter.
19. POWER CONTROL (12V)
These jack connectors (3.5 mm) send the signals
for the standby control (12V Trigger).
20. AUTO
Automatic shutdown in terms of eco design regu-
lation
If the unit is in non-use, this device switches off af-
ter about 15 minutes. It will then have a power
consumption of less than 0.4 W. In order to switch
on the device again, press the power button 1 time.
This function could be completely switched off by
putting the switch „Auto“ at the backside of the unit
to „Off“. This device has got no standby or armed
state. If you intend not to use the device for a lon-
ger period of time it is recommended to plug it off
from the mains.
21. SPEAKER A/B: Speaker connectors
Output sockets with screw clamps for connection of
two pairs of loudspeakers. You can use loudspeaker
cables with 4 mm banana connectors.
22. Voltage Selector:
The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information
(p. 40, “Switching the Voltage”)
23. PHASE
This LED lights up when the mains phase is incor-
rect. If this is the case, you should reverse the plug
in your socket.
24. AC 220-240V: Mains connector
To establish the power supply, connect the plugs
of the power cable to the device and to a suitable
wall outlet. The small plastic housing holds the fuse.
Refer to the security precautions.
REAR VIEW
